If you have Keurig Coffee Machine you should do proper maintenance for your machine, it is important to keep your machine in best performance as long as possible. For some of Keurig Coffee machine models brewers have alert when time to descale, then you should check your Keurig model have this function or not. You can maintain to cleaning your Keurig every 7- 11 Weeks, this is depends on your currently usage, you are less likely to run into issues like a half cup, an overflowing cup or maybe nothing happening at all. You need cleaning your machine If these problem do occur. Pairing these steps with a descaling hope will take care of nearly all Keurig brewer hiccups.
What You need to prepare
Table of Contents
Paperclip with one side straightened
Clean and fresh water
well prepare room, remove unnecessary item near you and your machine
Easy remove the portion pack assembly, remember all of the part
Then remove the funnel from the portion pack holder, just pulling on the sides until it detaches
Then locate the hole on the bottom of the exit needle you can check on the underside of the portion pack holder. Then Insert the unfolded side of the paperclip into the tube and move it in a circular motion to release any debris. You can repeat this step
Rinse the portion pack holder under running water and please beware of the exit needle. Or you can put them it in the dishwasher on the top shelf, just pick the easy one for you
Then locate the top entrance needle by lifting the handle on your brewer. For the needle is located under the brewer head (the part you lifted up). Then You will see two holes and a very sharp point (be careful!, just not in rush ).
Then insert the paperclip into the two holes of the entrance needle and move in a circular motion, this is to release any debris.
Replace the bottom portion pack assembly. Just make sure that it snaps back into place, and lower the brewer handle.
Run at least two water only brewer cycles.Then this is great time to descale using Keurig descaling solution.
A clogged Keurig® needles happens for the most often after brewing a tea K-Cup® pod. The tea tend to travel a little easier due to the lighter weight. Sometimes, running a water only brew cycle alone will remove the debris this is just alternative cleaner. If not, use the cleaning instructions described along with Keurig® descaling solution and you will enjoy your Keurig Coffee Machine again in a good performance